naxmentor.blogg.se

If the printout shows that the connection is Active and the SSID (network name) is BJNPSETUP, the printer's network settings have been reset to the factory defaults.Please refer to your firewall vendor's documentation for instructions on opening these ports.

If the printer responds to print commands after the firewall is disabled, you will need to open ports used by the printer for network communication. If the printout shows that the connection is Active and the signal strength is greater than 80%, try temporarily disabling any firewall software on your computer.If neither the printer nor the router can be moved, try removing obstacles between the two devices, or turning off any devices that may interfere with network communication. If the printout shows that the connection is Active and the signal strength is less than 80%, try to move the printer and router closer.Print out the network setting information.If there is still no response, move to the next step. After it has fully initialized, plug the printer back in and power it on.

Unplug your wireless router for 15 seconds, then plug it back in. If there have been no changes to your wireless network (new router, new password for your router, etc.), turn off and unplug your printer.If the printer is in an error state (paper jam, ink has run out, etc.) please address the error state first.